BE-15 Pipes and Materials: Welding of Plastic Pipes
Electrofusion welding
Working steps
- Clamping pipe ends axially and cutting them to length square to the pipe axis
- Measuring the welding zone and marking it
- Removing the oxide layer
- Trimming the pipe ends outside and inside
- Checking the roundness of pipes and adjusting, if necessary
- Cleaning pipe surfaces to be welded and interior side of the heated coil connector
- Inserting pipe ends into the heater coil connector
- Welding
|
/
87
Help for presentation mode
Show / hide the Table of Contents
Go to previous page
Go to next page
Show additional information for the current page
Show this help
Useful browser keystrokes
Typically, your browser supports the following keystroke commands:
[Ctrl]+[+] Enlarge text fonts
[Ctrl]+[-] Downsize text fonts
[Ctrl]+[F] Find text in local page