Midwest Mole Constructing 2,100-ft Tunnel as Part of INDOT Improvements Project
Aug 12, 2019
After years of collaboration between the City of Fishers, City of Noblesville, Hamilton County and Indiana Department of Transportation (INDOT) to address the traffic congestion and public safety challenges along the State Road (SR) 37 corridor, plans are underway to rehabilitate the corridor from 126th Street to 146th Street.
Hamilton County is the fastest-growing county in Indiana. The population of Fishers grew from 7,508 in 1990 to over 90,000 today, and Noblesville’s population grew from 17,655 to over 60,000 in the same timeframe. More than 50,000 vehicles now travel the corridor each day, and they are regulated at each of the cross streets with traffic signals that are becoming more overloaded as time passes.
Using a technique pioneered elsewhere in the region, SR 37 will be converted from a surface street to a freeway by constructing tight roundabout interchanges at existing intersections (plus one larger interchange) and depressing the SR 37 roadway. This allows the road to be upgraded to a freeway with limited displacement and for far less cost than constructing a new freeway.
In advance of SR 37 roadway improvements, infrastructure needs to be constructed to drain water from the newly depressed roadways. In October 2018, Midwest Mole, of nearby Greenfield, Indiana, was given Notice to Proceed on a project to build a 2,100-ft long, 84-in. excavated diameter tunnel for drainage improvements.
Midwest Mole is a full-service trenchless contractor that began operation in 1982. The active NUCA member provides a suite of underground construction services to municipal, utility, highway, railroad and private sector clients throughout the United States, including auger boring, microtunneling, pilot tube boring, pipe ramming, pipe jacking, tunneling and horizontal directional drilling.
For the SR 37 project, Midwest Mole’s contract involves constructing the 2,100-ft tunnel from a pit in a residential/commercial area, tunneling eastward to SR 37. As general contractor for the project, Midwest Mole was also responsible for site access construction, as well as a building a detention pond and outlet facility to Shoemaker Ditch.
Midwest Mole elected to use an 84-in. tunnel boring machine (TBM) to construct the tunnel using steel ring beams and wood lagging support. The TBM was supplied by NUCA Sustaining National Partner Akkerman Inc. Upon completion of the tunnel, crews will install 54-in. fiberglass pipe from Hobas Pipe as the final liner, grouted in place with cellular grout.
Because of the length of the tunnel – among the longest the company has built – Midwest Mole made some modifications to the machine. Crews extended the muck conveyor system to about 90 ft to accommodate a three-car muck train, allowing more efficient mucking and excavation.
Additionally, Midwest Mole equipped the TBM with an on-board electric hydraulic power pack. Typically designed for shorter distances, TBMs in this size range are usually powered by an electric hydraulic power pack located in the shaft with hydraulic oil lines installed along the length of the tunnel to power the TBM. An additional benefit to the on-board electric hydraulic power pack was reduced noise in the residential/commercial area.
“We were fortunate that we were able to bring power to the site to help keep it quiet – that was especially important because we were in immediate proximity to residents,” said Mike Liotti, project engineer for Midwest Mole. “In some places bringing power to the site can be a challenge, but in this case there was an existing high-voltage power drop for an ice rink within 700 ft of our main working site.”
“What is interesting about the ground is that there are not connected layers of geology – just pockets of different ground types and groundwater,” Liotti said. “You can be tunneling along and then suddenly you’re in a completely different type of ground in as little as 10 ft. It’s a very challenging environment for tunneling.”
Because of the variable ground, a closed face was specified. While the closed face is helpful in controlling the face of the tunnel in sandy and running conditions, it also makes it more challenging to deal with boulders.
To help break up boulders so they can pass through the cutterhead, crews are using the Micro-Blaster product from EzeBreak. Micro-Blaster, also used by demolition contractors, requires drilling a small hole into the boulder before activating a small blast or series of blasts to break up the rock. The small size of the blast hole eases the task of drilling, especially in cases where a boulder may be encountered in soft ground conditions.
As of late April, crews had mined approximately 780 lf of the 2,100-lf alignment, and have encountered approximately 20 boulders to date. The contract does offer a provision for dealing with boulders in excess of 18 in. in three dimensions: the first 4 hours of dealing with the obstruction are the responsibility of the contractor, while INDOT reimburses the contractor for work beyond 4 hours.
Three manholes are included in the project: one will be at the main work pit, one at the terminus, and one intermediate manhole at approximately 1,300 ft from the work pit. Midwest Mole expects a final completion date of May 2020 for site restoration, etc.
More News and Articles
Aug 21, 2019
100 Years Lifetime of Polyethylene Pressure Pipe Systems Buried in the Ground for Water and Natural Gas Supply
TEPPFA and PE100+ Association have identified the need for explaining the difference between the design point at 20 degree/50 years and the expected life-time of PE80 and PE100 pressure pipe systems. Research, extrapolation studies and reports on dig-up pipes in ...
Aug 20, 2019
ams , a leading worldwide supplier of high-performance sensor solutions, Qingdao iESLab Electronic Co., Ltd., a pre-eminent end-to-end supplier of smart municipal works, and innovative water utility company Jiangxi Water Group Co., Ltd., announce plans to extend their China Water ...
Aug 19, 2019
MyTana, a manufacturer and distributor of equipment for the plumbing and drain cleaning markets, has released DrainSteer. This patent-pending product combines the functionality of a high-pressure jetter and push camera to create the first steerable, jetting drain camera in the ...
Aug 19, 2019
Valuable insights into how the water sector can manage data more effectively will be given at an upcoming British Water event this autumn. "Data: Now & Beyond" will see speakers from key stakeholders, including water companies and the supply chain, ...
Aug 16, 2019
Wastewater treatment specialist WPL has made a rapid transition to the new health and safety standard set by the International Organization for Standardization (ISO). ISO 45001 Occupational Health & Safety standard was introduced in April 2018 and organisations are advised ...
Aug 15, 2019
The Construction Site Determines the Installation Technology: Light, Steam, Hot Water or Ambient Temperature.
Which curing method should ideally be used in the context of rehabilitation projects in building and site drainage? The market for the rehabilitation of building and property drainage is currently developing dynamically. The complexity of construction sites in particular places ...
Aug 14, 2019
The first European EN standard for oriented unplasticised poly(vinyl chloride) (PVC-O) pipes came out in April 2019, after an extensive four-year development process, initiated by TEPPFA. EN 17176 PVC-O piping systems for water supply and for buried and above-ground drainage, ...
Aug 13, 2019
Suqia Extends Deadline to Apply for 2nd Mohammed bin Rashid Al Maktoum Global Water Award to 1 September 2019
The UAE Water Aid Foundation (Suqia) extended the deadline to enter the second Mohammed bin Rashid Al Maktoum Global Water Award to 1 September 2019. Applicants participating in the award will compete to win prizes totalling USD 1 million. HH ...
Aug 09, 2019
Silicon Valley Clean Water Selects Name for the Tunneling Machine to Further Their $495 million Infrastructure Program
Silicon Valley Clean Water (SVCW) announced the selection of a name for their large tunneling machine that will support the agency’s $495 million infrastructure program. The program includes rehabilitating 3.3 miles of the agency’s raw wastewater conveyance piping system, involving ...
Aug 08, 2019
The city of Columbia, S.C., and Woolpert were honored by the South Carolina American Public Works Association with its 2019 SC APWA Project of the Year Award in the category of Structures/Historical Restoration for their Martin Luther King Jr. Park ...
Aug 08, 2019
On 1 June 2019, Maria Luisa Pérez Vergara (34) has been appointed Managing Director of MC-Bauchemie Belgium N.V. In this function, she is responsible for the Belgian business of MC-Bauchemie together with Benoit Verbiest (59).
Aug 07, 2019
A technology trial involving installation of 295 Enigma3m remote correlating noise loggers in a water distribution network in the State of Johor, Malaysia, has successfully cut net night flow by a third. Yoo Sun Chan, general manager, Primayer Sdn Bhd, ...